Spur band bending male/female die set
SKU:
$150.00
$150.00
1 1/4" Thick steel male and female die set
Width of the male die:
There is a 3/16" offset/gap for your spur band (this will work with 10ga and 3/16", but NOT 1/4" thick bands.
Bands can be bend hot or cold with this set, depending on your hydraulic press. Bands that are bent hot only require a few tons and can be done in an arbor press. Bands that are bent cold require 12 or more tons of pressure.
Width of the male die:
- Mans- 3 3/8"
- Woman/Youth- 3"
- Mans- Width 7 1/4" Height 5 3/4"
- Woman/Youth- Width 7 1/4" Height 5 3/4"
There is a 3/16" offset/gap for your spur band (this will work with 10ga and 3/16", but NOT 1/4" thick bands.
Bands can be bend hot or cold with this set, depending on your hydraulic press. Bands that are bent hot only require a few tons and can be done in an arbor press. Bands that are bent cold require 12 or more tons of pressure.